Home > Products > Crimping and Stripping > PA-09 / PA-20 / PA-21
PA-09 / PA-20 / PA-21 Connector-krimptang
More than 100 different terminals applicable
-
With 1 pair of our Connector Pliers, you can crimp in tidy finishing open-barrel connectors such as MOLEX, TE (Tyco), JST, HRS, etc.
-
D-Sub connector contact can be also crimped.
-
4-different cavities of elaborate dies
-
Original joint screw prevents the joint from being loose and offers you easy maintenance.
-
With locking latch and coiled spring
-
Oil resistant Elastomer (TPR) handle
Klik hier! [Krimpcontacttoepassingsschema]
JST-krimpcontacten
Video
Features
PA-09
Ideaal voor microconnectoren met een pitch van 1,25 mm en een pitch van 2,5 mm of D-sub-connectoren (#32 - #20 AWG-draden)
PA-20
Ideaal voor connectoren met een steek van 2,5 mm en 5 mm, matrijzen van 2,5 mm dik
(#28 - #18 AWG-draden)
PA-21
Ideal for 2.5mm pitch and 5mm pitch, also works with long-wing type of open-barrels owing to elaborately curved design of the upper die.
(#26 - #18 AWG wires)
Related Products
.jpg)
Perfect for crimping Dupont
(Servo) connectors [Male & Female]
How to select the suitable crimping dies
1. Measure the width of conductor barrel or insulation barrel with
a caliper while both barrel lugs are adjusted in parallel.
2. Selecteer de matrijsbreedte die dicht bij de breedte van de gemeten cilindernokken ligt. Voorbeeld: 1,5 mm gemeten -->> Selecteer 1,6 mm matrijzen.
3.
Conductor Barrel (Lug) Crimping :
It is better to offset the rearmost edge of conductor barrel (lug) 0.1-0.2 mm from the edge of the upper die to form a bellmouth on the edge of the crimped barrel. (as per the figure on the right)
Insulation Barrel (Lug) Crimping :
Set the insulation barrel (lug) at the center of the upper die in depth to keep the barrel (lug) horizontal when crimping.
.jpg)
Specificaties
