Casa > Prodotti > Crimpatura e spelatura > PAD-11 / PAD-12 / PAD-13
PAD-11 / PAD-12 / PAD-13 Handy Crimp Tool
Ultra-precise crimper forming excellent crimping finish!
-
Interchangeable die set for open-barrel contacts.
-
Easy replacement and perfect fitting to frame
-
Ergonomically-designed handles with strap hole
-
Equipped with wire stripper and cutter
-
2.5mm (Across flats) Hex key wrench included as standard accessory
Click here! [Crimp Contact Application Chart]
JST Crimp Contacts
Video
Caratteristiche
Crimpatura precisa ed eccellente
arricciatura del cilindro conduttore e del cilindro isolante individualmente.
Wire cutter with
stripping hole
Con fori per la cinghia
Easy fitting to frame. No need to adjust positioning. (PATENT)
1. Fissare un set di matrici intercambiabili.
2. Stringere le maniglie per chiudere le mascelle.
3. Mentre si afferrano le maniglie, fissare 4 pz. delle viti in modo sicuro.
PAD-11
Taglia S: oltre 90 terminali diversi applicabili
PAD-12
M-Size: Over 110 different terminals applicable
PAD-13
L-Size: Over 100 different terminals applicable
How to adjust the Joint-Screw
(1) Quando la vite di giunzione si allenta, è necessario rimuovere il lavoro
diventa opaco.
(2) Hold the hex bolt
(Reverse side) with a wrench.
(3) Fissare la vite del giunto con una chiave esagonale.
(Coppia inferiore a 2 N/m)
=CAUTION=
Do not attempt to adjust the bolt with nut from both sides with 2 pcs. of wrenches, which causes the screw joint broken. Use a hex key wrench for fastening with torque of less than 2 N/m.
How to select the suitable crimping dies
-
Before use, please make sure that wire size meets the standard provided by each connector maker and that the configuration and size of terminal is adaptable to the crimping dies.
-
Adjust both wings (lugs) of open-barrel to be in parallel before crimping.
-
Make sure that the crimp contact retains straight before insertion into a die cavity.
-
Do not lay the crimp contact inclined in a die cavity to avoid deforming in crimping work.
-
Do not squeeze handles so hard while crimping the insulation portion, which may cause disconnection of wires.
1. Measure the width of conductor barrel or insulation barrel with a caliper while both barrel wings are adjusted in parallel.
2. Select the die width that is close to the width of barrel lugs measured.
Example: 1.5mm measured -->> Select 1.6mm dies.
3.
Crimpatura del cilindro del conduttore (capocorda) :
Allineare il bordo posteriore del cilindro del conduttore con il bordo smussato della matrice superiore per formare una svasatura sul bordo del cilindro crimpato.
(come da figura a destra)
Crimpatura del cilindro isolante (aletta) :
Posizionare il cilindro isolante (aletta) al centro della matrice superiore in profondità per mantenere il cilindro (aletta) orizzontale durante la crimpatura.
.jpg)
Related Products
Interchangeable Die Set
PAD-11S / PAD-12S / PAD-13S
.jpg)
Specifications
