Home > Products > Screw Removal > DZ-76
DZ-76 Rapid Screw Extractor Set with Handle
Extractor bit set for stripped and broken screws !
-
Press & Twist type extractor bits for Philips #0, #1 & #2 screws and Strike &
Turn type extractor bits for Philips #2 screws -
Comes with an ergonomic handle grip with 13mm hex. bolster
-
Bit size : 105mm x Hex. 6.35mm
-
Bit material : High carbon steel
Video
Features
Ordinary Screwdriver
Rapid Screw Extractor
How to use
Press & Twist type (for slightly damaged screws)
１) Insert the bit into the handle grip.
２) Place the bit tip into the screw head, then scrape away
burs in the recess by twisting it back and forth lightly.
*Do not attempt to hit the bit with a hammer.
３) After you feel the bit tip catches the corner of recess,
give a jerk counterclockwise while pressing firmly
downward.
Strike & Turn type (for heavily damaged screws)
１) Clean out any steel chips left in the screw recess.
２) Fix the rubber sleeve to the Strike & Turn bit and position
the tip in the recess.
３) Strike the end of the bit with a hammer to stick the tip
into the recess.
４) Make sure the bit is self-standing upright, and then affix
the grip onto the bit.
*Do not hit the grip with a hammer.
５) Give a jerk counterclockwise while pressing firmly
downward.
Related products
Rapid Screw Extractor for Phillips
(DBZ-51/57/58)
Screw Extractor for Hex. Socket
(DBZ-53/54/56)
Rapid Screw Extractor
Handle Grip with DBZ-51/52 bits
(DBZ-60G)
High-torque Handle Grip for DBZ series
(DBZ-50B)
100mm in width
Go-through Driver Handle ø38 x 121(L) mm
with 13mm Hex Bolster and DBZ-51 Extractor Bit
(DZ-71)
DR-22 100mm
DR-23 150mm
DR-24 190mm
* DBZ-51~65 Extractors attachable
* The bit holder can be used with an Impact Driver, too.
DR-25 99mm
* DBZ-51~65 Extractors and DR-22~24 attachable
* Slide the sleeve forward to swing the tip to 15 degrees max.
* Can be used with an Impact Driver only in the straight mode.