Home > Products > Crimping and Stripping > PA-24
PA-24 Micro Connector Crimping Pliers
More than 170 different terminals applicable
-
Specialty of 2.5mm pitch connector contacts of different connector manufacturers, works with JST XH, PH, EH & NH series, Molex Micro-Fit, KK series, etc. AWG #32-#18
-
Perfectly crimps triangular insulation barrel (lugs) of DuPont (Servo) connector, Molex C-Grid III, etc. without damaging the insulations.
-
6 Crimping Dies ('m'-shaped crimp: 1.3, 1.6, 1.9 & 2.2mm in width &
Round crimp: φ1.4 & φ1.8mm) for open-barrel contacts -
Built-in screw cutter (M2, M2.6 & M3)
-
Tapered and slender jaws, Light weight of 115g only
-
Spring loaded (on the back side), with locking latch for easy handling
Click here! [Crimp Contact Application Chart]
JST Crimp Contacts
Video
Funktioner
M-formede dies [1,3, 1,6, 1,9 og 2,2 mm i bredden]
Lederløbet kan krympes sikkert. Isoleringstønden kan krølles meget pænt sammen.
Runde matricer (til DuPont-kontakt osv.) [φ1,4 & φ1,8 mm]
Vikl trekantede ører på tønden rundt om isoleringen uden at beskadige.
Screw Cutter M2, M2.6 & M3
Relaterede produkter
Line-up of Super Precision Crimping Pliers for open barrel terminals
PA-09
PA-20
PA-21
How to select the suitable crimping dies
1. Measure the width of conductor barrel or insulation barrel with
a caliper while both barrel lugs are adjusted in parallel.
2. Select the die width that is close to the width of barrel lugs measured. Example: 1.5mm measured -->> Select 1.6mm dies.
3.
Conductor Barrel (Lug) Crimping:
Det er bedre at forskyde den bagerste kant af ledertromlen (lugen) 0,1-0,2 mm fra kanten af den øvre matrice for at danne en klokkemunding på kanten af den krympede cylinder. (som vist på figuren til højre)
Isoleringstønde (Lug) Crimpning:
Indstil isoleringsrøret (knap) i midten af den øvre dyse i dybden for at holde cylinderen (knap) vandret, når der krympes.
.jpg)
Specifications
