Home > Products > Screwdrivers > DZ-70 / DZ-71 / DZ-72
DZ-70 / DZ-71 / DZ-72 Go-Through Screwdriver
Ergonomisk design for kraftigt drejningsmoment
-
⌀10mm iron core penetrates the handle, so the hammer impact can be transmitted directly to the tip.
-
With 13mm Hex. (Across Flats) bolster, works with a wrench to increase the (un)tightening torque.
-
Compatible with 6.35mm (1/4 inch) bits
Features
DZ-70
GO-THROUGH DRIVER (Handle only)
● Ergonomisk designet komforthåndtag, accepterer 6,35 mm driver-bit (bitlængde over 50 mm anbefales)
● Håndtaget er smalt i midten for at placere fingrene her for sikkerheden, og nyttigt til hurtig tilspænding.
Hex Bolster (på tværs af flade 13 mm)
Slaget med en hammer
overføres godt til spidsen
Rektangulær form
Smal i midten
Ball-shaped End
DZ-71
GO-THROUGH DRIVER
Extractor Bit contained :
Press & Twist type Bit to
remove #2 Phillips screw (DBZ-51)
4 edges of the cross tip can firmly grip
the remaining corners of Phillips recess.
Target Screws for DBZ-51
Flat & Round Head M3~5
Dome Head M4~5
DZ-72
GO-THROUGH DRIVER
Skruetrækkerbit indeholdt:
(＋) #2 skrue
Related products
■Set of DBZ-51, 52, 57 & 58 in a carrying case
-
DBZ-58 #0 Press & Twist
-
DBZ-57 #1 Press & Twist
-
DBZ-51 #2 Press & Twist
-
DBZ-52 #2 Strike & Turn
Works with stripped Phillips screws (#0, #1 & #2 sizes)
4-i-1 skrueudtrækkersæt (DBZ-22)
Længde 105mm x Hex. 6,35 mm
■Set of DBZ-62, 63, 64 & 65 in a carrying case
-
Works with 2~5mm (Across flats) stripped hex socket screws
-
Also useful as an extractor for other screw drives such as Phillips, Torx, etc. as per the following steps ;
(1) Drill a pilot hole in the center of screw head.
(2) Select the appropriate size of DBZ-62/63/64/65 (2mm, 3mm, 4mm or 5mm), which corresponds to the pilot hole (the diameter of the drill used).
(3) Apply a tip of the extractor and spin it counterclockwise while pressing downward. A power driver can be also used.
4-in-1 Socket Screw Extractor Set
(DBZ-20)
Length 105mm x Hex. 6.35mm
DR-22 100mm
DR-23 150mm
DR-24 190mm
* DBZ-51~65 Extractors attachable
* The bit holder can be used with an Impact Driver, too.
DR-25 99mm
* DBZ-51~65 Extractors and DR-22~24 attachable
* Slide the sleeve forward to swing the tip to 15 degrees max.
* Can be used with an Impact Driver only in the straight mode.
specifikationer
